Board index   FAQ   Search  
Register  Login
Board index VRRA Racing Forum Technically Speaking:

Rule Clarification # 2

Bike preparation, class eligibility, technical questions.

Moderator: Michael Vinten

Rule Clarification # 2

Postby Brian Stevenson » Sat Jul 27, 2024 9:10 am

Would like to take part in the PI race at Mosport but am having problems getting a bike put together.

The PI rules state the following...

Period:
The period of machinery eligible includes all motorcycles up to and including the year 1984

Engine Capacity
The following capacities are approved:
i. 2 Valve engines: 350cc to 1300cc
ii. 4 valve engines: 350cc to 1300cc
iii. Two cylinder engines: 350cc to 1400cc

My RZ350 is 1984 and is 350cc (obviously), therefore its eligible, yes?

Note, it says Two Cylinder Engines, there is no distinction if its a 2 stroke, 4 stroke or even a rotary. I have photos, video and race results showing the the RZ did historically compete in this class.

Also, in the original Formula TT classes that the PI rules were based on, the RZ350 (RD350 in Europe) and the original RD350LC were also eligible for F1 if the engine capacity was 351cc or greater. Less that 351 it was a F2 bike
Brian Stevenson
VRRA Member
 
Posts: 670
Joined: Sat May 05, 2012 3:28 pm
Location: Whitby, ON

Re: Rule Clarification # 2

Postby Michael Vinten » Tue Jul 30, 2024 3:29 pm

Not sure where the quote is from. The AHMRA rules for the Phillip Island class have a lower limit of 700cc for 2 valve, 4 valve or twin cylinders. Two strokes are allowed and can be water or air cooled.

https://www.ahrma.org/road-racing/phillip-island-challenge-rules/
Mike #19
Michael Vinten
Tech Committee
 
Posts: 2070
Joined: Tue Feb 04, 2003 8:47 pm

Re: Rule Clarification # 2

Postby Brian Stevenson » Tue Jul 30, 2024 8:18 pm

Hi Michael.

The AHRMA page is a sort of a cheat sheet for people who were building big bikes to go. The actual rules are here. https://www.phillipislandcircuit.com.au/wp-content/uploads/2012/10/2020-International-Challenge-Rules-and-Regulations-FINAL-2.pdf

The cut off is 84 so I guess that's why things like 43mm forks and 4 piston calipers are in there.
Brian Stevenson
VRRA Member
 
Posts: 670
Joined: Sat May 05, 2012 3:28 pm
Location: Whitby, ON


Return to Technically Speaking:

Who is online

Users browsing this forum: No registered users and 3 guests