Vintage Road Racing Association

Hi All,

I was hoping someone here could point me towards a shop in the Guelph or Kitchener/Waterloo area where I could get some cylinder reboring work done.

Back story -- putting together an RD400 and the bike runs, but the compression is low (90 psi). Engine was assembled when I got the bike. Going to pull the barrels and check things out, but it seems likely it'll need a top-end refresh. Just looking around now to line up a shop that could do the work.

Any details would be greatly appreciated.

Edit:

Okay, but of an update -- I work in Burlington/Oakville area, so no restrictions on the location now. I'd even head out Mississauga way if the shop was worth the drive.

Thanks

hey there..
you may want to re-post this in the Technical section as more people would see it..this is area is used for members promoting businesses..
good luck..
Scott